![]() ![]() With OpenVpn to the servers that are about 200 miles away down/up in the 350-500 range and latency in 14-15 ms range. With Wireguard to servers that are about 200 miles away down/up in the 700-800 range and latency in 16-17 ms range. I have 1000/1000 FIOS and running a speedtest via command line through WAN directly to Verizon servers about 60 miles away typically results in down/up in the 800-900 Mbps range with latency in the 9-10 ms range. I'd generated the config then requested the port forwards.Ĭompared to OpenVPN, peak speeds seem far more consistent (holding steady now at around 55mbps which is the upper limit of my current connection compared to ranging from 45-55), although CPU load has increased from an average of 40% to around said in WireGuard VPN providers that support how's the performance, already paying for 2 vpn providers, do i need a third.ha ![]() Although what wasn't clear was that in order to get port forwarding working correctly, you need to first request/configure the range within TG itself, then generate a new config. Once I'd properly set it to the vlan which uses it (so just swapping over ovpnc1 for wg0 on the gateway interface), everything was spot on. It was working fine, I'd just not interpreted the output of wg correctly. Then add any policy based rules to the firewall. Create a firewall rule under the wireguard interface to allow any. Leave everything else blank.Ĭreate and enable your Wireguard interface. The peer configuration is being copied from the config that was generated and plugged into all applicable fields in the tunnel peer settings. Click add peer on the bottom in the wireguard setup. Listen port should be listed as 51820 so enter that in the tunnel. Copy the address under interface and plug that into address in pfsense wireguard tunnel. You should have a config printed out in the box. Go back and enter those keys in the Torguard config generator and hit generate config button. Check Enable interface, add description, and go down and Generate New Keys. Go to pfsense VPN->Wireguard->Add Tunnel. Said in WireGuard VPN providers that support Go to the config generator, select tunnel type - wireguard, choose your server location and enter your VPN log in details. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |